NAS1101 at a glance
Where to buy
Specification
| Item | Value |
|---|---|
| Head | flat fillister, fully threaded |
| Drive | offset cruciform recess |
| Status | Check the current issue before design use. |
Part numbers and lengths
Sizes commonly stocked. The standard governs and may list other lengths.
.1380-322 part numbers
| Part no. | Length, in |
|---|---|
| NAS1101-06-6 | .375 |
| NAS1101-06-8 | .500 |
.1640-321 part numbers
| Part no. | Length, in |
|---|---|
| NAS1101-08-8 | .500 |
.1900-327 part numbers
| Part no. | Length, in |
|---|---|
| NAS1101-3-7 | .438 |
| NAS1101-3-8 | .500 |
| NAS1101-3-9 | .563 |
| NAS1101-3-10 | .625 |
| NAS1101-3-12 | .750 |
| NAS1101-3-16 | 1.000 |
| NAS1101-3-20 | 1.250 |
Part number
Notes from the standard
- Dash number: thread code (06 = .1380-32, 08 = .1640-32, 3 = .1900-32), then length in sixteenths of an inch.
- The distributor catalogue prints .1360 for code 06. #6-32 is .138 in MIL-HDBK-5J Table 8.1.5(b1), so .1380 is shown here.
- Part number written as the listing writes it; the standard governs the exact format.
- Approved data governs. Use the screw the SRM, drawing or IPC calls for.
Where to buy
AmericaDistributor coming soonOur partner for this region is on its way
EuropeDistributor coming soonOur partner for this region is on its way
OceaniaDistributor coming soonOur partner for this region is on its way
Distributors coming soon.
Sources
- NAS1101 — Screw, Machine, Flat Fillister Head, Full Thread, Offset Cruciform Recess — nominal sizes and part numbers.
Educational reference only. not approved data. Always consult the applicable SRM, AMM, or AC 43.13-1B and your certifying authority.