Specification
Where to buy| Item | Value |
|---|---|
| Type | Straight pulling head |
| Maker | Cherry Aerospace |
| Weight | 0.25 lb (0.11 kg) |
| Tool sheet | TS-H83HL-5MB, Rev. A, 05/04/11 |
Part numbers
| Part no. | Size |
|---|---|
| H83HL-5MB | 5/32 in (-5) |
Cherry's part numbers on this tool sheet.
What it installs as supplied
| Fastener | Diameter |
|---|---|
| 130 deg Titanium MAXIBOLT flush head (CR7774S-05) | 5 |
Riveters
Parts list
| Item | Part number | Description | Qty |
|---|---|---|---|
| 1 | 652-030 | COLLET | 1 |
| 2 | 744C75 | JAWS, -5MB | 1 |
| 3 | 652-031 | JAW FOLLOWER | 1 |
| 4 | 652-070 | SLEEVE, H83HL & H84HL | 1 |
| 5 | P-1425 | SPRING, COMPRESSION | 1 |
| 6 | 652-069 | DRAWBOLT ADAPTOR | 2 |
| 7 | 652-071 | NOSE PIECE, -5MB | 1 |
| 8 | P-1440 | DOWEL PIN | 1 |
| 9 | 652-076 | PRELOAD SLEEVE (H83HL-5MB) | 1 |
| 10 | 652-075 | RETAINER WASHER | 1 |
| 11 | P-1438 | POLYURETHANE SPRING | 1 |
| 12 | 652-074 | LOAD ADJUSTMENT NUT | 1 |
Notes from the maker
- Preload adjustment: thread load adjustment nut (12) hand tight against polyurethane spring (11) with a wrench; to increase preload tighten nut (12); if not properly tightened preload element loses effectiveness.
- Sleeve assembly procedure: thread nosepiece (7) into sleeve (4); thread nut (12) over sleeve; push spring (11), retainer washer (10), preload sleeve (9); insert collet assembly; press dowel pin (8). Hand riveters: make sure pressure released and correct adaptors used.
- Clean insert, jaws and jaw cavity every 1,000 installations or on failure; lubricate outside of jaws with Lubriplate; grease tapered area of jaws. Use Loctite 242 on threaded elements. Make sure nut is snug against polyurethane spring (item 11); do not over-tighten.
Where to buy
AmericaDistributor coming soonOur partner for this region is on its way
EuropeDistributor coming soonOur partner for this region is on its way
OceaniaDistributor coming soonOur partner for this region is on its way
Distributors coming soon.
Sources
- Cherry Aerospace, Tool Sheet TS-H83HL-5MB, Rev. A, 05/04/11 — Pulling Head for -5 Dia 130 deg MAXIBOLT Titanium Flush Head
Educational reference only. not approved data. Always consult the applicable SRM, AMM, or AC 43.13-1B and your certifying authority.