AN30 — clevis bolt, 5/8, 5/8-18 UNF-3A

Notes from the standard

• Dash number sets the grip and length. Add A after the dash number for a bolt without the cotter pin hole: AN30-14 has the hole, AN30-14A has none.
• Grip is measured from the underside of the head to the end of the full cylindrical portion of the shank; two imperfect threads max.
• Lengths longer than those tabulated are available in 1/8 in increments by use of significant dash numbers.
• Rated tensile strength applies only when shear nut AN320 or thin nut AN364 is used.
• Cotter pin hole centerline within .010 of the bolt centerline for 5/16 dia bolts and smaller, and within .015 for 3/8 dia bolts and larger; hole normal to the bolt centerline within 2°.
• Thread T per MIL-S-7742, except that the major diameter shall not exceed the maximum allowable shank diameter. Fillet under the head R .005 to .015.
• Head marked with a double X, raised or depressed .010 max; only one X need be visible after slotting. Position of the slot relative to the cotter pin hole is optional.
• Unless otherwise specified: decimals ±.010, fractions ±1/64, angles ±5°. Countersinking of drilled holes is optional.
• Approved data governs. Use the bolt the SRM, drawing or IPC calls for.